optimization command
Syntax
- extrude mesh optimization i
Specify optimization level 0 ≤ i ≤ 10 for the unstructured mesher. The default value is 5.
A zero value makes the mesher to skip the optimization step. The speed is maximal but the quality may be poor. From value 1 on, the optimization algorithm uses several techniques to improve both the shape quality and the size quality of the zones. Level 5 is usually a good trade-off between quality and speed.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |