add command

Syntax

extrude segment add keyword

Primary keywords:

position    number

Adds segment(s).

position f keyword

When specified, an existing segment is split at the location f. If f falls past the end a new segment is added.

group s1 <slot s2 >

Assign the created segment the group name s1 (in slot s2 if provided, in slot Default if not).

node-group s1 <slot s2 >

Assign the created nodes of the segment the group name s1 (in slot s2 if provided, in slot Default if not).

ratio f

Set the ratio f of zone size distribution along the segment.

size i

Set the number of zones i along the segment.

number i keyword

When specified, then i new segments are added onto the end.

group s1 <slot s2 >

Assign the created segment the group name s1 (in slot s2 if provided, in slot Default if not).

length f

Set the segment length f.

node-group s1 <slot s2 >

Assign the created nodes of the segment the group name s1 (in slot s2 if provided, in slot Default if not).

ratio f

Set the ratio f of zone size distribution along the segment.

size i

Set the number of zones along the segment.

Note

Use of the group logic is described in the Group topic.