automatic-zone command
Syntax
- extrude set automatic-zone keyword
-
Set automatic zoning of the extrusion set.
- direction keyword
Control which part(s) of the extrusion are auto-zoned. If not specified, the last value specified is retained (the default is both).
- both
Auto-zoning is applied to both the 2D construction data, and the 1D extrude segment data. This is the default.
- construction
Auto-zoning is applied to the 2D construction data only.
- extrusion
Auto-zoning is applied to the extrude segment data only.
- edge f
Auto-zoning will attempt to keep the average length of a zone edge to the value f. If not supplied, the previous value will be used. The default value is 1.0.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |