structure beam history command
Syntax
- structure beam history <name s > keyword
-
Samples beam responses that include force and moment carried by the beam. The force and moment vectors are expressed in the element local coordinate system (see Figure 1.17 for sign convention). If a beam is created using the
structure beam create
command, then the nodes of each element so created will be ordered such that the overall beam direction goes from the first point to the second point (i.e., the nodal connectivity of each element will be ordered such that the direction from end-1 to end-2 corresponds with the direction from the first point to the second point).- force [beamhistoryoptions]
request a history of beam force magnitude
- force-x [beamhistoryoptions]
request a history of beam forces in the x-direction
- force-y [beamhistoryoptions]
request a history of beam forces in the y-direction
- force-z [beamhistoryoptions]
request a history of beam forces in the z-direction
- moment [beamhistoryoptions]
request a history of beam bending moment magnitude
- moment-x [beamhistoryoptions]
request a history of beam bending moment in the x-direction
- moment-y [beamhistoryoptions]
request a history of beam bending moment in the y-direction
- moment-z [beamhistoryoptions]
request a history of beam bending moment in the z-direction
Keyword Block
Either the component-id keyword or the position keyword must be supplied. The end keyword is optional.
force
,force-x
,force-y
,force-z
,moment
,moment-x
,moment-y
andmoment-z
.
- component-id i
the particular element is identified by the component ID number. If this keyword is used, position should not be used.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |