structure geogrid list command
Syntax
- structure geogrid list keyword <range>
Primary keywords:
apply coupling depth-factor element-type group information force-node property resultant stress stress-principal system-local
List properties and response of each geogrid element in the range.
- apply
uniform applied pressure acting on the element
- coupling
Information about the shear coupling springs connecting the liner to the zones. The confining stress, displacement, yield state, and direction is given.
- depth-factor
depth factor used during stress recovery
- element-type
finite element type used
- group <slot s >
list the group assignment(s) of this element. If slot is supplied, list the group assignment for this element, if any, in slot s.
- information
Lists general element information, including id and component-id numbers, connected nodes, centroids, surface area, volume, and the hide and select status.
- force-node keyword
List nodal forces. By default, components are displayed in terms of the element local coordinate systems. These are the forces exerted by the nodes on the element.
- local
List forces in terms of the element local coordinate system (the default).
- global
List forces in terms of the global coordinate system.
- property
- density
density, ρ
- thickness
geogrid thickness
- thermal-expansion
thermal expansion coefficient
- anisotropic-membrane
anisotropic membrane material-stiffness coefficients { cʹ11, cʹ12, cʹ13, cʹ22, cʹ23, cʹ33 }
- anisotropic-bending
anisotropic bending material-stiffness coefficients { cʹ11, cʹ12, cʹ13, cʹ22, cʹ23, cʹ33 }
- anisotropic-both
anisotropic bending and membrane material-stiffness coefficients { cʹ11, cʹ12, cʹ13, cʹ22, cʹ23, cʹ33 }
- material-x
Vector used to determine the local X direction of the material coordinate system.
- isotropic
isotropic material properties: E and v, where E is Young’s modulus [F/L2] and v is Poisson’s ratio
- orthotropic-membrane
orthotropic membrane material-stiffness coefficients { cʹ11, cʹ12, cʹ22, cʹ33 }
- orthotropic-bending
orthotropic membrane material-stiffness coefficients { cʹ11, cʹ12, cʹ22, cʹ33 }
- orthotropic-both
orthotropic membrane material-stiffness coefficients { cʹ11, cʹ12, cʹ22, cʹ33 }
- coupling-cohesion
coupling spring cohesion (stress units)
- coupling-friction
coupling spring friction angle (degrees)
- coupling-stiffness
coupling spring stiffness per unit area
- slide
large-strain sliding flag
- slide-tolerance
large-strain sliding tolerance
- resultant <nodes>
all eight stress resultant quantities last calculated with the
structure geogrid recover resultants
command. If the nodes keyword is given the values of these quantities is supplied at each node of the element, in addition to the value at the element centroid.
- stress <nodes>
the stress state calculated with the
structure geogrid recover stress
command. If the nodes keyword is given the values of these quantities is supplied at each node of the element, in addition to the value at the element centroid.
- stress-principal <nodes>
principal stresses calculated with the
structure geogrid recover stress
command. If the nodes keyword is given the values of these quantities is supplied at each node of the element, in addition to the value at the element centroid.
- system-local
element local coordinate system
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |