structure link tolerance-contact command
Syntax
- structure link tolerance-contact f
Set the tolerance used when establishing node-to-zone links. A node is considered to be in a zone if it is within a distance d of the zone boundary, where δ equals f times zone size (taken as the maximum x-, y-, or z-dimension of the zone bounding box). Nodes that are used by elements with their sliding flag on will utilize
structure link tolerance-slide
instead of f when attempting to update the zone interpolation point of an existing link. By default, f equals 1 × 10-5.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |