structure node system-local command
Syntax
- structure node system-local keyword <range>
-
Set the orientation of the node-local system for all nodes in the range.
At the start of a set of cycles, the orientation of the node-local system is set automatically based on the type of elements that use the node; however, this behavior can be overridden by setting the orientation of the node-local system with the
structure node system-local
command, and then using thestructure node fix system-local
command.At least two directions must be given. The third direction will be calculated to be perpendicular to the first two. Of the two directions given, the higher degree-of-freedom will be corrected to ensure it is perpendicular to the other two.
- x v
specifies the local x-direction
- y v
specifies the local y-direction
- z v
specifies the local z-direction
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |