ball results command
Syntax
- ball results keyword ...
Primary keywords:
Modify the usage of the ball results logic. This logic allows for a reduced version of the model state (i.e., ball geometries plus ball attributes) at different instances of time to be output as binary files. The ball result can be used to re-create the model state, acting as a utility for efficient post processing (e.g., movie generation, residence time calculations, etc.). A ball result file DOES NOT replace a PFC model state file and models re-created with this logic should not be cycled. See the
model results
command to specify when results files are created and how to import these files subsequently.- active b
Set the status of ball result creation.
- add-attribute s
Add the ball attribute s (as defined in the
ball attribute
command) to be recorded in the ball result. When the result is re-created, this attribute will be filled. All ball attributes can be listed with theball list attribute
command. Ball group and extra variables can also be added using the group and extra keywords.
- remove-attribute s
Remove the ball attribute s (as defined in the
ball attribute
command) to be recorded in the ball result. Ball group and extra variables can be removed using the group and extra keywords.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |