ball thermal list command
Syntax
- ball thermal list <keyword> <range>
-
List thermal ball information. By default, the thermal ball ID, temperature, and fixity are listed. Use the attribute keyword to list all thermal ball attributes that can be listed.
Note
Use the
model precision
command to change the precision of listed floating point values.- attribute <s >
List thermal ball attributes. If no s is given, then the available attributes are listed. If s is specified, then the value of that attribute is listed for each thermal ball. Attributes are characteristics of thermal balls such as temperature and unbalpower. These are distinct from properties that represent surface conditions and are used in contact models to delineate interactions.
- contact <all>
List the contacts with a thermal ball. The contact ID, ID of the other contacting piece, contact type, activity state, inhibited state, and contact model are listed. By default, only active contacts are listed. Use the all keyword to list active and inactive contacts.
- property <s >
List ball properties. If no s is given, then the available properties are listed for each thermal ball. If s is specified, then the value of that property is listed for each ball.
Properties represent surface conditions and are used in contact models to delineate interactions. These are distinct from attributes, which are characteristics of balls such as temperature and unbalpower.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |