clump thermal list command
Syntax
- clump thermal list <keyword> <range>
-
List thermal clump information. By default, the thermal clump ID, temperature, and fixity condition are listed. Use the attribute keyword to list all thermal clump attributes.
Note
Use the
model precision
command to change the precision of listed floating point values.- attribute <s >
List thermal clump attributes. If no s is given, then the available attributes are listed. If s is specified, then the value of that attribute is listed for each thermal clump. Attributes are characteristics of thermal clumps such as temperature and unbalpower. These are distinct from thermal pebble properties that represent surface conditions and are used in contact models to delineate interactions.
- contact <all>
List the contacts with a thermal clump. The contact ID, ID of the other contacting piece, contact type, activity state, inhibited state, and contact model are listed. By default, only active contacts are listed. Use the all keyword to list active and inactive contacts.
- property <s >
List clump properties. If no s is given, then the available properties are listed for each thermal clump. If s is specified, then the value of that property is listed for each clump.
Properties represent surface conditions and are used in contact models to delineate interactions. These are distinct from attributes, which are characteristics of thermal clumps such as temperature and unbalpower.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |