wall thermal list command
Syntax
- wall thermal list <keyword> <range>
-
List thermal wall information. By default, the thermal wall ID, temperature, and fixity condition are listed. Use the attribute keyword to list all thermal wall attributes.
Note
Use the
model precision
command to change the precision of listed floating point values.- attribute <s >
List thermal wall attributes. If no s is given, then the available attributes are listed. If s is specified, then the value of that attribute is listed for each thermal wall. Attributes are characteristics of thermal walls such as temperature and unbalpower. These are distinct from thermal facet properties that represent surface conditions and are used in contact models to delineate interactions.
- contact <all>
List the contacts with a thermal wall. The contact ID, ID of the other contacting piece, contact type, activity state, inhibited state, and contact model are listed. By default, only active contacts are listed. Use the all keyword to list active and inactive contacts.
- property <s >
List thermal wall properties. If no s is given, then the available properties are listed for each thermal wall facet. If s is specified, then the value of that property is listed for each thermal wall facet.
Properties represent surface conditions and are used in contact models to delineate interactions. These are distinct from attributes, which are characteristics of thermal walls such as temperature and unbalpower.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |