rblock list command
Syntax
- rblock list <keyword> <range>
-
List rigid block information. By default, the rigid block ID, active/total contact count, fixity, and position are listed. Use the attribute keyword to list all rigid block attributes that can be listed.
Note
- Use the
model precision
command to change the precision of listed floating point values.
- attribute <keyword>
List rigid block attributes. If no keyword is given, then the available attributes are listed. If a keyword is specified, then the value of that attribute is listed for each rigid block.
Attributes are characteristics of rigid blocks such as mass and velocity. These are distinct from properties that represent surface conditions and are used in contact models to delineate interactions.
- contact <all>
List the contacts with a rigid block. The rigid block ID, contact ID, ID of the other contacting piece, contact type, activity state, inhibited state, and contact model are listed. By default, only active contacts are listed. Use the all keyword to list active and inactive contacts.
- property <s >
List rigid block properties. If no s is given, then the available properties are listed for each rigid block.
Properties represent surface conditions and are used in contact models to delineate interactions. These are distinct from attributes that are characteristics of balls such as mass and velocity.
- result
List the rigid block model results that have been tabulated. See the
rblock results
command for more details.
- Use the
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |