rblock thermal list command
Syntax
- rblock thermal list <keyword> <range>
-
List thermal rigid block information. By default, the thermal rigid block ID, temperature, and fixity are listed. Use the attribute keyword to list all thermal rigid block attributes that can be listed.
Note
Use the
model precision
command to change the precision of listed floating point values.- attribute <s >
List thermal rigid block attributes. If no s is given, then the available attributes are listed. If s is specified, then the value of that attribute is listed for each thermal rigid block. Attributes are characteristics of thermal rigid blocks such as temperature and unbalpower. These are distinct from properties that represent surface conditions and are used in contact models to delineate interactions.
- contact <all>
List the contacts with a thermal rigid block. The contact ID, ID of the other contacting piece, contact type, activity state, inhibited state, and contact model are listed. By default, only active contacts are listed. Use the all keyword to list active and inactive contacts.
- property <s >
List rigid block properties. If no s is given, then the available properties are listed for each thermal rigid block. If s is specified, then the value of that property is listed for each rigid block.
Properties represent surface conditions and are used in contact models to delineate interactions. These are distinct from attributes, which are characteristics of rigid blocks such as temperature and unbalpower.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |