block zone size command

Syntax

block zone size keyword <range>

Primary keywords:

center    clear    edgelength    by    block-gridpoint    block-face    isolated-point    list

Set zoning conditions for deformable blocks prior to using the block zone generate-new command.

center v keyword ...

Generate a radially graded mesh from point v. If center is inside a block, a uniform mesh with edge length of edgelength-center f will be generated.

edgelength-1 f

Set the edge length at a distance Distance-1 from the center point to f.

distance-1 f

Set a distance f from the center point at which edgelength-1 will be used.

edgelength-2 f

Set the edge length at a distance Distance-2 from the center point to f.

distance-2 f

Set a distance f from the center point at which edgelength-2 will be used.

clear

Clears all sizes specified with all \(block zone size\) commands.

edgelength f <keyword>

The parameter f defines the average edge length of tetrahedral zones. By default, the size is set for blocks in the range.

by keyword

block-gridpoint

Specify that zone size should be applied to gridpoints in the range. In this way, zone size can vary across a block.

block-face

Specify that zone size should be applied to faces in the range. In this way, zone size can vary across a block.

isolated-point v

Specify the zone size near an isolated point v inside a block. If the coordinates of an existing gridpoint are given, the command will still work, but the isolated point will not be listed with the list keyword.

edgelength f

The parameter f defines the average edge length of tetrahedral zones near Isolated-Point.

list

Prints to the console the coordinates and edge lengths of all isolated points.