index command

Syntax

extrude segment index i keyword ...

Primary keywords:

group    length    node-group    position    ratio    size

Modify a segment by ID.

group s1 <slot s2 >

Assign the segment the group name s1 (in slot s2 if provided, in slot Default if not).

length f

Set the segment length f.

node-group s1 <slot s2 >

Assign nodes of the segment the group name s1 (in slot s2 if provided, in slot Default if not).

position f

Set segment position. Note that segments may be split, deleted, or extended.

ratio f

Set the ratio f of zone size distribution along the segment. This setting defines zone sizes relatively along the segment, where the size of each zone will be f of the previous zone length. The default value is 1.0 (uniform zones — same length).

size i

Set the number of zones i (integer) along the segment.

Note

Use of the group logic is described in the Groups topic.