model configure command
Syntax
- model configure keyword ...
Configure an additional calculation mode.
This command allows the user to specify that the model is using calculation modes that either require extra resources or are restricted by the current license.
The model.configure command can be given at any stage of an analysis, but it must be given before the calculation mode (
model solveormodel cycle) can be invoked.The following keywords apply.
- cfd
PFC CFD analysis
- creep
Creep material analysis*
- dynamic
Fully dynamic analysis*
- energy
Energy tracking in 3DEC
- feblock
Finite element blocks in 3DEC
- fluid
Fluid-flow analysis
- highorder
Include higher-order tetrahedra in the model (must be given before blocks are created in 3DEC).
- hotetra
Include higher-order tetrahedra in the model (must be given before blocks are created in 3DEC).
- imass
The Itasca Model for Advanced Strain Softening*
- matrixflow
Matrix flow in 3DEC
- plugins
C++ user-defined models and/or FISH intrinsic plugins.* FISH plugins can be loaded (but cycling is disabled) without this configuration.
- thermal
Thermal analysis
Note
*These analysis modes are available only if the corresponding program option is included in the program license.
| Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |