Rolling Resistance Linear Model Properties
The properties of the Rolling Resistance Linear Model are shown below for reference. More detailed information regarding these properties is presented here.
Note
Some properties are read only as stated below.
- dp_force v
\(\mathbf{F^d}\) - dashpot force in units force. Expressed in the contact plane coordinate system. This is a read-only property.
- dp_mode i
\(M_d\) - dashpot mode with default value 0.
- dp_nratio f
\(\beta_n\) - normal critical damping ratio with default value 0.0.
- dp_sratio f
\(\beta_s\) - shear critical damping ratio with default value 0.0.
- emod f
\(E^*\) - effective modulus in units force/area. This is a read-only property.
- fric f
\(\mu\) - friction coefficient with default value 0.0.
- kn f
\(k_n\) - normal stiffness in units force/length with default value 0.0.
- kratio f
\(\kappa^*\) - normal-to-shear stiffness ratio. This is a read-only property.
- ks f
\(k_s\) - shear stiffness in units force/length with default value 0.0.
- lin_force v
\(\mathbf{F^l}\) - linear force in units force with default value \(\mathbf{0}\). Expressed in the contact plane coordinate system.
- lin_mode i
\(M_l\) - normal-force update mode with default value 0 (absolute update mode). Incremental normal-force update mode is set with \(M_l\) = 1.
- lin_slip b
\(s\) - slip state. This is a read only property.
- rgap f
\(g_r\) - reference gap in units length with default value 0.0.
- rr_fric f
\(\mu_r\) - rolling friction coefficient.
- rr_kr f
\(k_r\) - rolling resistance stiffness. This is a read-only property.
- rr_moment v
\(\mathbf{M^r}\) - rolling resistance moment. Expressed in the contact plane coordinate system.
- rr_slip b
\(s_r\) - rolling slip state. This is a read only property.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Oct 14, 2024 |