create
command
Syntax
- sketch segment create keyword
-
Create a segment or a set of segments.
- automatic
Automatically create segments from a background geometry present in a set. The background geometry usually represents an imported CAD geometry (e.g., a DXF or STL files).
- by-points i1 i2 <keyword>
Create a segment between two points with the IDs i1 and ID i2.
- group s1 <slot s2 >
Assign the created segment the group name s1 (in slot s2 if provided, in the slot named Default if not).
- ratio f
Set the ratio f (a number between 0.1 and 10.1), which is used to distribute zone lengths along the segment (each zone will be f of the size of the zone preceding it). This setting automatically propagates across dependent segments of regular blocks while
Ratio-Isolate
is false.
- ratio-isolate b
The option only applies to the segments which form regular (3- or 4-sided) blocks.
Set the flag to control ratio propagation. Ratio settings propagate when false (the default). If set true a ratio assignment on this segment will not propagate to dependent segments.
- size i
Set the number of zones on the segment. This setting automatically propagates across dependent segments of regular blocks.
- type keyword
Specify the curve type of the segment.
- arc
- polyline
- simple
This is the default type (a line).
- spline
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 14, 2024 |