block joint-plane
command
Syntax
- block joint-plane b <keyword>
-
Toggle calculations for plotting joint planes. This setting controls the calculation of data structures used for plotting joint planes. The data structure takes time to calculate and uses a lot of memory. Eliminating this calculation affects plotting only; it does not affect any mechanical calculations.
- delete
Delete existing joint-plane data structures.
- tolerance f
Set tolerance for merging nodes. If nodes are closer together than f, they will be merged. The default is 0.1 times the block tolerance (
block tolerance
).
- new b
Toggle use of new joint plotting algorithm. Default is \(on\).
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |