zone creep
command
Syntax
- zone creep keyword
Primary keywords:
Sets parameters for a time-dependent creep material analysis (only available with the creep model option – see Section 1 in Creep Material Models). These parameters apply to zones only, other model elements may have different values.
- active b
Set the creep process
on
for zones. This setting ison
by default when themodel configure creep
command is given. Generally this setting is unnecessary and is inherent in to themodel configure creep
setting. Specifyactive
off
to suppress the creep calculation for zones.
- list
Display creep calculation-mode information.
- time-total f
Specify the accumulated zone creep time, defined as the sum of all the timesteps over which zone creep is active. Once set, creep time will continue to accumulate with subsequent cycles.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |