zone trace
command
Syntax
- zone trace keyword
Primary keywords:
Trace zone position and velocity. See the c trace commands.
The positions and velocities of locations on the zone can be sampled and stored during a model run by using this command. The resulting path through space can be visualized with the FLAC interface. Only one trace position may be created per
zone trace
command. Traces may be added at any time.A summary of all traces can be obtained by using the
trace list
command.The following keywords are available to specify which zone location is traced.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |