zone face apply-remove
command
Syntax
- zone face apply-remove <keyword> <range>
Note
- The following nomenclature / equivalence between FLAC3D and FLAC2D is used:
Zone faces = zone surface faces in 3D or zone edges (lines connecting gridpoints) in 2D
There is no 2D equivalence for 3D zone edges
Remove
zone face apply
conditions, which are described in the documentation for that command. If an optional range is supplied, the condition is removed only from those faces within the range. If no keyword is specified, then all conditions applied to the specified faces are removed.- acceleration
- acceleration-dip (3D ONLY)
- acceleration-local
- acceleration-normal
- acceleration-strike (3D ONLY)
- acceleration-tangential (2D ONLY)
- acceleration-x
- acceleration-y
- acceleration-z (3D ONLY)
- convection
- discharge
- flux
- head
- leakage
- pore-pressure
- quiet
- quiet-dip (3D ONLY)
- quiet-normal
- quiet-strike (3D ONLY)
- quiet-tangential (2D ONLY)
- reaction
- reaction-dip (3D ONLY)
- reaction-local
- reaction-normal
- reaction-strike (3D ONLY)
- reaction-tangential (2D ONLY)
- reaction-x
- reaction-y
- reaction-z (3D ONLY)
- stress-dip (3D ONLY)
- stress-normal
- stress-strike (3D ONLY)
- stress-tangential (2D ONLY)
- stress-xx
- stress-xy
- stress-xz (3D ONLY)
- stress-yy
- stress-xz (3D ONLY)
- stress-zz (3D ONLY)
- temperature
- velocity
- velocity-dip (3D ONLY)
- velocity-local
- velocity-normal
- velocity-strike (3D ONLY)
- velocity-tangential (2D ONLY)
- velocity-x
- velocity-y
- velocity-z (3D ONLY)
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |