zone.field.tol
Syntax
- f := zone.field.tol() (3D ONLY)
- zone.field.tol() = f
Get/set the tolerance used for the polynomial method of extrapolation. The default is 1e-7.
This value is used to detect a degeneracy in the matrix used to solve for polynomial extrapolation coefficients. If a degeneracy is detected, the matrix is revised to assume there is no change in that degree-of-freedom.
- Returns:
f - the tolerance used for polynomial method of extrapolation
- Accepts:
f - the tolerance used for polynomial method of extrapolation
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |