zone.hysteretic
Syntax
- f := zone.hysteretic(z,s)
- zone.hysteretic(z,s) := f
Get/set the hysteretic damping parameter s in zone z. s can have the following possible values: c0, c1, c2, c3, modfac, reduction-minimum, model, e1, e2, e3, e4, e5, and e6.
c0, c1, c2, and c3 return/set the first through fourth parameters of the hysteretic model.
model returns/sets the hysteretic model identification number, where 1 = Default model, 2 = off, 3 = Sigmoidal-3 model, 4 = Sigmoidal-4 model, 5 = Hardin model., and 6 = Ramberg-Osgood
modfac returns/sets the current reduction factor.
reduction-minimum returns/sets the assigned lower-bound of the reduction factor. The default is 0.005.
e1 through e6 return/set strain components \(γ\)1 … \(γ\)6. See Hysteretic damping for more details.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |