Verification Problems
- Measure Logic
- Strength of a Face-Centered Cubic Array of Spheres
- Tip-Loaded Cantilever Beam
- Linear Contact Model: Calibrating the Normal Critical Damping Ratio
- Hertz Contact Model: Complex Loading Paths
- Wave Propagation in Particle Assemblies
- Rolling Resistance Linear Contact Model: Single Ball on a Flat Surface
- Rolling Resistance Linear Contact Model: Repose Angle
- Adhesive Rolling Resistance Linear Contact Model: Repose Angle
- Burger’s Contact Model: Stress Relaxation
- Sliding Wedge
- Spring Network Contact Model Capabilities
- Simulating Square Permanent Magnets
- Pull-Test for a Grouted Cable Anchor in a PFC Rigid Block Model
- Shear Pull-Tests for a Hybrid Bolt in PFC3D
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |