zone joint create-contact
command
Syntax
- zone joint create-contact keyword ...
Primary keywords:
Create contacts between specified zone joints. The ranges apply to zone faces on either side of the joints. If no ranges are specified then contacts between all facets are created. This operation is only necessary if contacts have not been created with the
zone joint create
command.- range-1 <keyword ...>
Specify the range used to select zone faces on one side of the joint.
- range-2 <keyword ...>
Specify the range used to select zone faces on the other side of the joint.
- tolerance f
Specify the relative contact detection tolerance. By default the relative contact detection tolerance is 1e-8.
- tolerance-angle f
Specify the angular tolerance, in degrees, between zone face normals for contacts to be created. By default the angular tolerance is 2 degrees. This is a global value.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |