structure liner cmodel command

Syntax

structure liner cmodel keyword

Primary keywords:

assign    list

Assign or get information about liner constitutive models. This command allows assignment of a constitutive model to a specified liner element, and querying properties and states of constitutive models.

assign keyword <range>

Assign the specified constitutive model to all elements in the range. If a model has already been assigned, this replaces the existing one with the new one. If the constitutive model is replaced, then the nodal forces acting on the element remain the same. The properties of the newly assigned constitutive model will be default values, and should be set with the structure liner property command.

elastic

isotropic elastic model (see the Beam Elastic Constitutive Models description).

list keyword

names <s >

Output available liner constitutive model keywords and full names. Output is restricted to the model named s if supplied.

properties <s >

Output the property list for each liner constitutive model. Output is restricted to the model named s if supplied.

states <s >

Output the state flags for each liner constitutive model. Output is restricted to the model named s if supplied.