Commands
Operations on structural element liners are listed here.
2D liner elements use the same internal formulation as beam elements, except the Young’s modulus is scaled to reflect plane strain conditions.
By default they are deformable, and connected on one side. They are assumed to be placed on a surface of the model,
and, therefore, link interactions normal to the element surface are directional. They are unique in the structural element logic for the
ability to support two links on each node, allowing liners to be embedded between two surfaces
(using the embedded
keyword during creation).
Structural Element Liner (2D) Commands
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 05, 2024 |