building-blocks block create
command
Syntax
- building-blocks block create keyword
Primary keywords:
Create a block or blocks.
- from-faces <distance f > <keep-shape b > range
Create blocks attached to the faces specified by the
range
. All faces here must be external faces — each face is attached to one block only. New blocks will be “extruded” from the faces along the average face normal. The extruded distance is defined by f. If f is not supplied the default distance will be related to the maximum diagonal extent of a block among all the blocks attached to supplied faces. The keep-shape option specifies whether the shape of the starting face will be maintained in the extruded face. Face shape will be maintained using edge end points and edge control points but not face control points.
- axial s origin v1 radius f sweep f zones i tolerance f range
Create blocks attached to the faces specified by the
range
. All faces here must be external faces — each face is attached to one block only. The new blocks will rotate around the specified origin point and axis to create axial symmetry. All the keywords are required. The axis string should be “X”, “Y”, or “Z”. The radius is the shortest distance from the axis to the closest point in the selection. Sweep is the sweep angle ranging from just above zero (depending on the specified tolerance) to a maximum of 90 degrees. Zones is the number of zones per 45 degrees to assign to edges in the sweep direction. Tolerance specifies how close points can be before they’re considered to be in the same place.
- hexahedron <by-points v1 v2 v3 v4 v5 v6 v7 v8 > <group s <slot s >>
Create a hexahedral block. by-points, if present, must be followed by points that define the block (a hexahedron requires eight points). The optional keywords group and slot assign the created block to the specified group and slot.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 05, 2024 |