building-blocks point move-to command

Syntax

building-blocks point move-to keyword f <control-point b > <range>

Move points. Position components (\(x\), \(y\), or \(z\)) of points in the <range>, if supplied, are moved to the value f; all points are moved if no range is supplied.

The <control-point b> option for the edges with control points indicates whether control-points on an edge should move if only one of the points of that edge is moved. For the faces with control points the option indicates where control-points of a face should move if not all of the face points are moved. The default is true.

x

Set the \(x\)-component of the point(s).

y

Set the \(y\)-component of the point(s).

z

Set the \(z\)-component of the point(s).