wall results command

Syntax

wall results keyword ...

Primary keywords:

active    add-attribute    remove-attribute

Modify the usage of the wall results logic. This logic allows for a reduced version of the model state (i.e., wall geometries plus wall attributes) at different instances of time to be output as binary files. The wall result can be used to re-create the model state, acting as a utility for efficient post processing (e.g., movie generation, residence time calculations, etc.). A wall result file DOES NOT replace a PFC model state file and models re-created with this logic should not be cycled. See the model results command to specify when results files are created and how to import these files subsequently.

active b

Set the status of wall result creation.

add-attribute s

Add the wall attribute s (as defined in the wall attribute command) to be recorded in the wall result. When the result is re-created, this attribute will be filled. All wall attributes can be listed with the wall list attribute command. Wall group and extra variables can also be added using the group and extra keywords.

remove-attribute s

Remove the wall attribute s (as defined in the wall attribute command) to be recorded in the wall result. Wall group and extra variables can be removed using the group and extra keywords.

Usage Example

wall result active on

from “Hopper.dat” in Hopper Discharge

wall result add-attribute velocity

from “fragment.dat” in Fragmentation Analysis during a Uniaxial Compression with Crack Tracking Using Fractures