Commands
Create the ball-zone coupling data structures. This coupling allows for overlapping balls and zones to experience a kinematic correction.
Note
- In order for PFC to cycle in a coupled fashion, FLAC3D must be configured for dynamics and run in large strain mode.
This is set with the
model largestrain
andmodel configure dynamic
commands. - The contact, PFC and ball-zone plugins must be loaded either via the menu item or with the
program load module
command. In order to visualize PFC model components, PFC gui plugin must also be loaded; theprogram load guimodule
command is used in this case.
Ball-Zone Commands
ball-zone create |
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |