- wipp-salt
- activation-energy f
activation energy, Q
- bulk f
bulk modulus, K
- bulk-final f
final, intact salt, bulk modulus, Kf
- constant-a f
WIPP model constant, A
- constant-b f
WIPP model constant, B
- constant-d f
WIPP model constant, D
- constant-gas f
gas constant, R
- compaction-0 f
creep compaction parameter, B0
- compaction-1 f
creep compaction parameter, B1
- compaction-2 f
creep compaction parameter, B2
- creep-rate-critical f
critical steady-state creep rate, ε̇*ss
- density-final f
final, intact salt, density, ρf
- density-salt f
density, ρ
- exponent f
WIPP model exponent, n
- poisson f
Poisson’s ratio, v
- shear f
elastic shear modulus, G
- shear-final f
final, intact salt, shear modulus, Gf
- temperature f
zone temperature, T
- young f
Young’s modulus, E
- compaction-bulk f
[read only] creep compaction parameter, K
- compaction-shear f
[read only] creep compaction parameter, G
- density-fractional f
[read only] current fractional density, Fd
- Notes:
- Only one of the two options is required to define the elasticity: bulk modulus K and shear modulus G, or Young’s modulus E and Poisson’s ratio v.
- The creep behavior is triggered by deviatoric stress, while the volumetric behavior does not consider creep.
- The two densities: density-salt ρ, and density-final ρf , should be considered as internal variables for the constitutive level calculation only, which should not be confused with the real material density.
Footnote
Read-only properties cannot be set by the user. However, they may be listed, plotted, or accessed through FISH.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |