building-blocks edge factor command
Syntax
- building-blocks edge factor f <range>
Apply a sizing factor to zones on edges. The factor is applied to edges in the current <
range
>, if supplied, or on all edges if not. The factor f must be between 0.001 and 1000.0 (the default is 1.0).When zones are generated from the blocks, the factor (like a ratio, see
building-blocks edge ratio
) defines zone sizes of relative length along the edge block. Factor specifies a ratio of last zone length to the first zone length along an edge.When the factor for an edge is changed, the change is propagated to all face-connected opposite edges. If
building-blocks edge ratio-isolate
is set to true the changes will not propagate from the edge; the default setting of that flag is false.[CS: a picture here might be in order]
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |