building-blocks edge ratio-isolate command
Syntax
- building-blocks edge ratio-isolate b <range>
Determine whether zone ratios or factors propagate. Each time the zone size factor (
building-blocks edge factor
) or ratio (building-blocks edge ratio
) of an edge is changed, the changes are propagated to all face connected opposite edges. Ifbuilding-blocks edge ratio-isolate
is set to true, the changes will not propagate from the edge. The default setting is false.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |