building-blocks edge size command
Syntax
- building-blocks edge size i <range>
Specify the number of zones on an edge. The value of i must be positive (up to 1000). The default value is 3. When zones are generated from the building blocks set, all blocks attached to an edge in <
range
> will have i zones along the direction defined by the edge. If <range
> is not supplied all edges are affected.Each time the size on an edge is changed, the changes are propagated to face-connected opposite edges.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |