building-blocks face add-controls command
Syntax
- building-blocks face add-controls keyword <no-edges-cp> <range>
Add control points to faces. Control points are added on all faces in the current building blocks set if <
range
> is not supplied.- i
Add exactly i X i control points (grid) per each face (i must be a positive integer 0,2,3,…,20). Added control points will be evenly spaced. Also will add i CPs per each internal edge from the list of the faces. If i = 0 control points are removed.
- no-edges-cp
Optional. Skip adding-removing CPs to-from edges.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |