building-blocks face cycle command
Syntax
- building-blocks face cycle <range>
Rotate (cycle) the topology of triangular faces. Aspects of the face, such as the degeneracy point, edge zone sizes, and ratio, are affected when the topology is changed.
The operation is performed on faces in the <
range
>, if supplied, or on all faces if not. However, note only triangular faces are affected by the command. The cycle operation will propagate through wedge or tetrahedral blocks across attached faces.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |