clump results command

Syntax

clump results keyword ...

Primary keywords:

active    add-attribute    remove-attribute

Modify the usage of the clump results logic. This logic allows for a reduced version of the model state (i.e., clump geometries plus clump attributes) at different instances of time to be output as binary files. The clump result can be used to re-create the model state, acting as a utility for efficient post processing (e.g., movie generation, residence time calculations, etc.). A clump result file DOES NOT replace a PFC model state file and models re-created with this logic should not be cycled. See the model results command to specify when results files are created and how to import these files subsequently.

active b

Set the status of clump result creation.

add-attribute s

Add the clump attribute s (as defined in the clump attribute command) to be recorded in the clump result. When the result is re-created, this attribute will be filled. All clump attributes can be listed with the clump list attribute command. Clump group and extra variables can also be added using the group and extra keywords.

remove-attribute s

Remove the clump attribute s (as defined in the clump attribute command) to be recorded in the clump result. Clump group and extra variables can be removed using the group and extra keywords.