clump rotate command
Syntax
- clump rotate keyword ... <range>
Primary keywords:
Rotate clumps. Application with the point keyword may also modify the center of mass location. Rotations follow the right-hand rule where the rotation axis in 2D is toward the viewer. Rotations are not allowed that rotate clumps so that pebble centroids fall outside the model domain. No clumps will be rotated if any clumps fail this test. Should orientation tracking be active, then the orientation is updated by default, though this can be disabled (see the update-orientation keyword).
- axis vaxis
Axis of rotation.
- angle fang
Angle of rotation in degrees using the right-hand-rule.
- point vrot
Rotation occurs about the specified point. Should this keyword be absent, rotation occurs about the centroid of each clump.
- update-orientation b
Explicitly set the orientation update status for this rotate command. Used if orientation tracking is enabled to update the orientation. By default, the orientation is updated.
Usage Example
Please see the clump template
example for a demonstration of the clump rotate
command.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |