block face list
command
Syntax
- block face list keyword <rigid> <range>
Primary keywords:
bad-edge bad-normal check extra group information position vertices
List information about block faces. Output is for deformable blocks only; the keyword rigid, if supplied, will invert output to rigid blocks only.
- bad-edge
List block faces that have 3 vertices along a single edge; used in diagnosing problems with zoning.
- bad-normal
List block faces that have normals that do not point out from the center of the block (inverted faces).
- check
List information from an internal check on the data structures associated with the face sub-contact logic. It is used in diagnosing problems.
- extra i
List extra variable information.
- group
List group names.
- information <keyword>
List general face information, including face number, block number, normal vector, area, joint number, and group name. This is the default keyword for the
block face list
command.
- position
List the position of face centroids.
- vertices
List the vertices that make up the faces in the range.
Was this helpful? ... | PFC © 2021, Itasca | Updated: Feb 25, 2024 |