flowknot initialize
command
Syntax
- flowknot initialize keyword <range>
Initialize flotknot variables in the range. Note that the [flowknotinitializeoptions] is available after each of the following keywords, allowing them to be varied in space independently.
- pore-pressure f [flowknotinitializeoptions]
Set initial flowknot pore-pressure.
- temperature f [flowknotinitializeoptions]
Set initial flowknot temperature.
- extra f [flowknotinitializeoptions]
Set initial flowknot extra variable values.
Keyword Flow
The following keywords may be used to modify a supplied scalar value. The commands main keywords are: extra
, pore-pressure
and temperature
.
Was this helpful? ... | PFC © 2021, Itasca | Updated: Feb 25, 2024 |