block jointplane
command
Syntax
 block jointplane b <keyword>

Toggle calculations for plotting joint planes. This setting controls the calculation of data structures used for plotting joint planes. The data structure takes time to calculate and uses a lot of memory. Eliminating this calculation affects plotting only; it does not affect any mechanical calculations.
 delete
Delete existing jointplane data structures.
 tolerance f
Set tolerance for merging nodes. If nodes are closer together than f, they will be merged. The default is 0.1 times the block tolerance (
block tolerance
).
 new b
Toggle use of new joint plotting algorithm. Default is \(on\).
Was this helpful? ...  3DEC © 2019, Itasca  Updated: Mar 10, 2023 