zone results command
Syntax
- zone results
Primary keywords:
active attach displacements extra forces groups interfaces model-fluid model-mechanical model-thermal pore-pressure saturation stresses temperatures velocities water
Controls if and what values are saved from zones in an exported results file. See the
model results export
command. By default zones values are active. The values being exported by default are stresses, groups, and displacements.- active b
Controls if any zone values will be exported.
- attach b
all attach condition information
- displacements b
displacement vectors at gridpoints
- extra b
all extra variables at zones and gridpoints
- forces b
unbalanced force information at gridpoints, including the last local force ratio.
- groups b
Group assignments to zones, faces, and gridpoints
- interfaces b
all interface information
- model-fluid b
all fluid constitutive model information
- model-mechanical b
all mechanical constitutive model information
- model-thermal b
all thermal constitutive model information
- pore-pressure b
pore pressure values at gridpoints
- range <range>
Specifies a range used to filter which zones are included in a results file export. This range is saved and restored as part of the model state. Note that this facility is still somewhat experimental, and there may be issues if zone-dependent features like attach, apply, etc. are also included in a results export.
- saturation b
saturation values at gridpoints
- stresses b
average stresses in each zone. Note that the internal tetra stresses are never exported.
- temperatures b
temperature values at gridpoints
- velocities b
velocity vectors at gridpoints
- water b
all water table information.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |