zone.temp
Syntax
- f = zone.temp(z)
- zone.temp(z) = f
Get/set the zone temperature. Normally this is the average temperature of the gridpoints. If the
zone thermal zone-based-temperature
command was used, then temperatures are stored and retrieved directly from the zone.Returns: f - the average zone temperature Accepts: f - the temperature to store in the zone; only valid if zone thermal zone-based-temperature
has been set to trueArguments: z - a zone pointer
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |