block zone size
command
Syntax
- block zone size keyword <range>
Primary keywords:
Set zoning conditions for deformable blocks prior to using the
block zone generate-new
command.- center v keyword ...
Generate a radially graded mesh from point v. If center is inside a block, a uniform mesh with edge length of edgelength-center f will be generated.
- clear
Clears all sizes specified with all \(block zone size\) commands.
- edgelength f <keyword>
The parameter f defines the average edge length of tetrahedral zones. By default, the size is set for blocks in the range. Use the
by
keyword with a specified range to apply the size to gridpoints (range by block-gridpoint
) or to faces (range by block-bface
).
- isolated-point v
Specify the zone size near an isolated point v inside a block. If the coordinates of an existing gridpoint are given, the command will still work, but the isolated point will not be listed with the
list
keyword.- edgelength f
The parameter f defines the average edge length of tetrahedral zones near Isolated-Point.
- list
Prints to the console the coordinates and edge lengths of all isolated points.
Was this helpful? ... | PFC © 2021, Itasca | Updated: Feb 25, 2024 |