Logo  

Commands

These commands examine or modify the general model state. These are either settings that are saved/restored/reset along with the model, or general model controls that do not pertain to a specific module (like zone, structure elements, or ball).

Model Commands

model calm
model clean
model configure
model creep
model cycle
model deterministic
model display
model domain
model dynamic
model energy
model factor-of-safety
model fluid
model gravity
model history
model large-strain
model list
model mechanical
model new
model orientation-tracking
model precision
model random
model range
model restore
model results
model save
model solve
model step
model thermal
model title
model update-interval
  • model calm command
  • model clean command
  • model configure command
  • model creep command
  • model cycle command
  • model deterministic command
  • model display command
  • model domain command
  • model dynamic command
  • model energy command
  • model factor-of-safety command
  • model fluid command
  • model gravity command
  • model history command
  • model large-strain command
  • model list command
  • model mechanical command
  • model new command
  • model orientation-tracking command
  • model precision command
  • model random command
  • model range command
  • model restore command
  • model results command
  • model save command
  • model solve command
  • model step command
  • model thermal command
  • model title command
  • model update-interval command
⇄
  • PFC 7.0 documentation »
  • Program Guide »
  • Common Model Objects »
  • Model »


⇐ Model | model calm command ⇒
Was this helpful? ... PFC © 2021, Itasca Updated: Nov 12, 2022