Sketch Options
There is a “Sketch” panel in the Options Dialog where user-configurable aspects of the Sketch workspace may be set. (Access the dialog from the Tools Menu.)

Figure 1: The “Sketch” panel of the Options dialog
Constraining Angle: sets the constraining angle when drawing edges with the point-edge tool while the Ctrl key is pressed. This behavior is described in the topic Create Edges.
Default edge type: designates the edge type for any newly drawn edge (which will be one of “line”, “curve”, or “arc” based on the setting here).
Point-edge mode: determines the method for adding edges in the construction view. Segment mode adds one edge at a time. Polyline mode adds edges continuously until you exit the mode.
Was this helpful? ... | Itasca Software © 2022, Itasca | Updated: Mar 09, 2023 |