zone creep command
Syntax
- zone creep keyword
Primary keywords:
This command sets parameters for a time-dependent creep material analysis (only available with the creep model option – see Section 1 in Creep Material Models). These parameters apply to zones only, other model elements may have different values.
- active b
The creep process is on for zones, by default, when the
model configure creep
command is given. Specify active off to suppress the creep calculation for zones. Generally this command is unnecessary and is slaved to thezone creep active
setting.
- list
Display creep calculation-mode information.
- time-total f
Specifies the accumulated zone creep time, defined as the sum of all the timesteps over which zone creep is active. Once set, creep time will continue to accumulate with subsequent cycles.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |