zone face westergaard command
Syntax
- zone face westergaard <keyword> ... <range>
Primary keywords:
Applies the Westergaard approximation for the dynamic response of water to the surface faces in the range. This operates by changing the inertial mass of the gridpoints connected to the surface faces in the range. This command is only available if
model configure dynamic
has been specified.As with most c zone face commands, this command will only operate on surface faces in the range.
- direction f
reversal direction of the hydrodynamic wave propagation. This direction must be in horizontal plane.
- height f
height of the water in the reservoir
- base f
elevation of the base of the reservoir
- density-water f
density of the water in the reservoir
- factor f
optional coefficient, the default value is 0.743
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |